Categories
News

Custom Vinyl Decal Application Directionsvinyl Decal Installation

Custom Vinyl Decal Application Directionsvinyl Decal Installation. All of our orders are mailed to keep the decals safe. Getting to know your decal. Vinyl Decal Application Directions Vinyl decals, Vinyl, Monogram decal from www.pinterest.com First about decal application you need to know each decal has 3 pieces: Spray the solution on the back of the […]

Custom Vinyl Decal Application Directionsvinyl Decal Installation. All of our orders are mailed to keep the decals safe. Getting to know your decal.

Vinyl Decal Application Directions Vinyl decals, Vinyl, Monogram decal
Vinyl Decal Application Directions Vinyl decals, Vinyl, Monogram decal from www.pinterest.com

First about decal application you need to know each decal has 3 pieces: Spray the solution on the back of the vinyl lettering. Read these instructions from start to finish before beginning!

Start Peeling Back The Decal At A 45 Degree Angle While Applying The Squeegee To The Freshly Removed Area To.

Room temperature or 60 to 74 degrees fahrenheit is ideal for vinyl decal application. All of our orders are mailed to keep the decals safe. Be sure the vinyl lettering is adhering to the application tape, which.

Vinyl Decal Full Application Instructions.

Place the vinyl lettering face down and peel away the waxed paper. You should read these instructions all the way through before starting. The middle layer is the actual vinyl decal.

The Top Layer Is The Transfer Tape.

Read them again so you are completely familiar with the process. Spray the solution on the back of the vinyl lettering. Install a transfer cut decal.

Pay Special Attention To Level And Center The Vinyl Decal Itself And Not The Backing.

Read these instructions from start to finish before beginning! If your decals are intended for wet application, you’ll need to take slightly different steps: Depending on the size of the order most orders will be mailed in a white rigid.

Run A Piece Of Tape Vertically Over The Center Of The Graphic Making Sure It Adheres Firmly Above And Below.

Then, position the graphic over the masking tape inside the lines and hold it in place. Place the decal on the destination surface. Clean the surface to remove any grease, dirt, and dust that might.

Leave a Reply